|
Glow Worm Unvented Cylinders
|
The new range of mains-fed domestic hot water
cylinders from Glow-worm are designed for use with UK boilers in hot water
systems.
Available in six sizes; 115, 150, 175, 200, 250 and 300 litres, they are
suitable for all sizes of property from a small single bathroom property up
to a large two bathroom property with en suite shower room. Manufactured
from high grade stainless steel with all seams laser welded they are built
to last and carry a 25 year guarantee against perforation of the steel
shell. The cylinders operate directly from a mains water pressure supply and
do not require a feed from a cold-water storage tank. The 22mm DHW outlet
and cold water mains inlet connections ensure optimum flow rates.
Performance is further enhanced by insulation that achieves heat loss as
little as 1.7kW per 24 hours and a high-recovery heating coil that provides
recovery in as little as 20 minutes. All cylinders are also provided with an
auxiliary back up 3kW electric immersion heater, including operating
thermostat and energy cut out. As with all Glow-worm products installation
is simple with all the connections at the front of the cylinder.
Main Features
- Stylish mains-fed unvented domestic
hot water cylinders
- Volumes of 115L / 150L / 175L /
200L / 250L / 300L
- High grade stainless steel cylinder
- Laser welded seams
- Insulation meets CHeSS best
practice (as low as 1.7kW/24hr)
- High recovery heating coil (as low
as 20 minutes)
- Stand-alone cylinder (complies with
G3)
- High flow rates achievable working
at 3.5bar pressure
- External expansion vessel
(supplied)
- Expansion vessel wall mounting
bracket (available as an accessory)
- Dimensions of 600mm at widest point
(all models)
- Simple front connection compression
fittings
- Back-up immersion heater on all
models
- Covered controls and wiring box
- Simple maintenance (no anode
required)
- 25 year warranty for perforation of
shell
|